Then, when I start zwave inclusion on hubitat after manually waking the strip, it will SOMETIMES show up as a found Zwave device, but shortly after hubitat says that it is initializing, the LED on the strip gives 5 short blinks, which I presume means failure. I THINK i'm ultimately able to get the thing reset. Not sure which set of instructions is correct, or if either work.
Then, when I actually try it, I don't get one blink, I usually get two, sometimes three! WTF?
Shows putting magnet 2cm from curves end, waiting for a blink, then moving it back and forth between curved and and logo twice, then rest it at curved end for 10 second until long blink Reset instructions from where i bought it: Shows moving from the middle to the curved end 3 times, then letting it remain at curved end for 10 seconds I will probably try bringing that device someplace far away so it can't be discovered just to make sure it isn't something in the DB.Īlso no matter which browser I use (iOS Chrome, Safari, Firefox, Edge or Windows IE, Firefox, Edge) I cannot stop a Z-Wave include or exclude once they have begun without going back to another window and back, neither of the stop buttons does any more than saying stopping for a second but the timer keeps counting down. Any ideas? I have seen many others with devices stuck on initializing but have not seen support talk about it, and I haven't seen it get stuck detecting a device that shouldn't be discoverable any more. I also tried a Z-Wave repair hoping that would clean up whatever is happening but this morning I still get the message that it found device 37. I joined it to Hubitat but it got stuck saying Found device with ID 37 initializing but after 5 minutes it hadn't finished and I've had this happen many times in the past so I went to the devices page and looked for the device and it wasn't there so I tried again, immediately upon starting the z-wave include it saw the device and got stuck again, I tried this about 10 times and tried to exclude it again but couldn't get it to see the exclusion so I decided to pair it to my SmartThings hub to get Hubitat to stop seeing it and leave it for now but after finally getting it paired to SmartThings again Hubitat still shows the same message each time I start a Z-Wave inclusion. Last night I tried to add a Sensative Strip Guard to my system which I had finally managed to exclude from SmartThings (exclusion and pairing requires moving the magnet over an unmarked area so your never sure it will work).
Hubitat version 2.1.3.128, I know this is a version back but when I updated to the latest version last week my Z-Wave devices where extremely slow and reverting back to 2.1.3 resolved that.
0 kommentar(er)
